Hello, There is a problem with Fenix A320 on MSFS 2020 and FSRealistic. After completing pushback and engine start, default Fenix A320 profile starts working problematic. I start to hear full thrust sound without any movement on the airplane. However, after a while, because of this sound, airplane's brake temperature dramatically increases and give warning on the cockpit. Note: As soon as I close the FS realistic, unwanted engine full thrust sound gone. That means there is a problem with Fenix A320. Could you please help me about the problem that I mentioned above? Regards, Hakan
top of page
bottom of page
I noticed that it doesnt happen if you wait until tow truck disconnected to start engine 1. Basically, I use FSR, GSX and the Fenix normally. During pushback, I start engine 2, and I wait for the tow truck disconnection and the nose to be back on ground to start engine 1. Dont had any brake temp issue when proceeding like this.
BTW, it had also happened to me a few times without using FSR. Im sure its a GSX problem. But without FSR, it happened only on random occasion. With FSR, it happened 100% of the time. But my technique should work, regardless if you are using FSR or not.
i'm back to the 2.0.4 FSrealistic vers and this problem disappeared. Update need to solve this problem with 2.0.6 version...
"Note: As soon as I close the FS realistic, unwanted engine full thrust sound gone. That means there is a problem with Fenix A320."
Negative, just the sound gone but the problem remain. Try to make a pushback with the GSX and Fenix without FS realistic... In this case all the process run perfect
The same for me. After update Fenix the problem continued. Impossible make push back with GSX when the FS Realistic it's running. I need close FS Realistic and make the PB with GSX. After the PB is ready i run again FS Realistic. I did many tests and the Issue is with the FS Realistic...
Do you use gsx? Fenix had this problem they updated and it fixed!